![]() I know there are tons of lights on amazon, but I would like to stick to something UL/DLC ideally (not just the cable being UL rated lol). ![]() Here are a couple more options for the UFO I'm considering, some of these have adjustable lumen & cct color which would be useful because I don't think I would install any dimming switch. I was pretty set on getting 4ft strip lights like this, but then stumbled upon the LED UFO lights which seem to be pretty similar priced, but offer much more lumen output? I'm thinking of something along these lines: I currently have 8 ceiling junction boxes that I had outfitted for lights. I used a few online calculators, and it looks like with my setup, I would need 35,000 lumens to achieve the minimum of 50fc. But the 1x4 rectangular version, FP1X4/4WY/WH/HD, did work with the Caséta dimmer in my brief testing.So, the results:Both the 74202/CA and 74206/CA in their current revisions, did basically work. There's a 8圆 corner bump out in one of the back walls, meaning it's not a complete rectangle. I will probably go ahead and install these in one room before using them in additional rooms and waiting for a newer revision.Here's the garage details all walls & ceiling drywalled, painted white. ![]() High Light Plants (such as tomatoes, peppers, perennials, etc) would benefit from 6 distance during the seeding stage, and a distance of 16-30 during vegetative/flowering stage. They also have a very slight buzz, which was louder in the 6-inch version than the 4-inch. A: Thank you for your question, the amount of distance and time used all depends on the type of plant being grown. However, when turned on, they did briefly flash before ramping up. They did not show any light in the off position, looked good at even the lowest dim setting, and I could change colors at the switch, including the reset sequence. But the 1'x4' rectangular version, FP1X4/4WY/WH/HD, did work with the Caséta dimmer in my brief testing.So, the results:Both the 74202/CA and 74206/CA in their current revisions, did basically work. Attached to either, the light just continued to flash. These fixtures are made exclusively for Home Depot.The Rev code on the 74202 is 082818-17 (factory 0828, Manufactured in the 17th week of 2018).The Rev code on the 74206 is 062018-17 (factory 0620, Manufactured in the 17th week of 2018).Feit claims they are always improving dimmer compatibility, so later revs may perform better (or worse).I felt the need to test these because I have previously installed the 15-inch version, 74212/HD, and it did not work with either the standard Caséta dimmer nor Lutron's Maestro CL Dimmer with Motion Sensor. 50-Watt 4000 Lumens White Dimmable Integrated LED Edge-Lit Flat Panel Flush Mount Light Color Changing CCT. There is also a hard-to-find V2 version that is $2 cheaper and does not include the adapter. These are also California Title 24 compliant if you don't use the screw-in adapter. I really like edge-lit fixtures, as you don't have the glare that normal LED fixtures give off. I couldn't find anyone who'd tested these, so I bought one each of the Feit 74202/CA (4-inch edge-lit, round, selectable color (3000-4000-5000) on the fixture or by toggling the light switch, 500-lumen, 6.5-watt) and 74206/CA (same, but 6-inch, 800-lumen, 10.5-watt).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |